Teacup Birdfeeder

Teacup BirdfeederThese teacup bird feeders are an excellent way to recycle old cups and saucers.  And they are both whimsical ornaments for the garden and work great as feeders.

 

Materials:
Teacup and saucer
Drill
1/8 inch ceramic tile bit
1/4 inch masonry bit
36 inch long 1/4 inch threaded metal rod
30 inch long copper tubing 1/2 inch wide
2 stainless steel nuts with 1/4 inch wide hole
2 stainless steel washers with 1/4 inch wide hole
Safety Glasses
Gloves
Marker
Birdseed

Drilling HoleDirections:
First collect your cups and saucers. A good place to look is a resale shop or junk store.

Next prepare your cup and saucer. Mark the center of each and carefully drill a hole through them one at a time. To reduce breakage and frustration, first make a starter hole with the 1/8 inch ceramic tile bit and then widen it with a 1/4 inch masonry bit.

Saucer and CupNow take the 36 inch long, 1/4 inch wide threaded metal rod and screw a nut about 1/2 inch from the top, place a washer on top of the metal nut and then the saucer and cup on top of the washer.

At this point you will have the tea cup and saucer balanced on the metal nut and washer with about 1/2 an inch or less of the threaded rod rising up through the middle of the tea cup.

Adding Copper TubingTake your second washer and slip it over the threaded rod so that it sits flat inside the teacup. Next add a metal nut on top of the washer and screw it down tightly so that the teacup and saucer are secure.

Select the area in your garden where you would like to place the feeder, push the copper tubing into the ground about 2 or 3 inches and then insert the threaded metal rod down into the ground through the copper tubing to give the feeder a finished look.